180i - 180MHz Pentium Pro, introduced on September 23, 1996
200i - 200MHz Pentium Pro, introduced on September 23, 1996
200i² - 200MHz Pentium Pro, introduced on September 23, 1996
266i - 266MHz Pentium II
300i - 300MHz Pentium II
350i - 350MHz Pentium II
400i - 400MHz Pentium II
266i+ - 266MHz Pentium II
300i+ - 300MHz Pentium II
333i+ - 333MHz Pentium II
These workstations support either one or two microprocessors and use standard Intel chipsets: Pentium Pro models use the Intel 440FX, Pentium II models suffixed with "i" use the Intel 440BX whereas ones suffixed with "i+" use the Intel 440LX. A superscript "2" suffix indicates a dual processor configuration.
The i-Series has four DIMM slots on its main logic board and supports standard unbuffered or registered 100MHz ECCSDRAM DIMMs. Using unbuffered memory, the i-Series can support 32 to 512 MB of memory, with registered memory, 64 MB to 1 GB is supported. Unbuffered and registered DIMMs cannot be mixed in the same system. Unbuffered DIMMs have capacities of 32, 64 and 128 MB, whereas registered DIMMs have capacities of 64, 128 and 256 MB.
a-Series
The Digital Personal Workstation a-Series, code named "Miata", uses the Alpha 21164A microprocessor. Models suffixed with "a" run Windows NT (with AlphaBIOS) as shipped, whereas models suffixed with "au" run Digital UNIX or OpenVMS (with SRM). Both models can be switched between AlphaBIOS and SRM via the system firmware.[3] At COMDEX 1997, the Digital Personal Workstation 500a was a finalist in Byte magazine's Best of Show award for the best workstation category.[4]
Models included the:
433a/433au - 433MHz Alpha 21164A
500a/500au - 500MHz Alpha 21164A
600a/600au - 600MHz Alpha 21164A
The Alpha microprocessor is socketed in a zero insertion force (ZIF) socket and can be upgraded. These workstations use Digital's 21174 chipset, also known as the "Pyxis" chipset. To increase flexibility and to reduce cost, the L3 cache is optional in these models. If the L3 cache is required, a cache module that contained the SRAMs which implemented the cache can be installed into a cache slot. The cache module has two capacities: 2 or 4 MB.
Two revisions of the Miatamotherboard were produced, known as MX5 and MiataGL respectively. The later MiataGL motherboard has a revised Pyxis chipset (which fixes a PCIDMA bug), a different ATA controller, an on-board QLogic 1040 SCSI host adapter, and a USB interface.[5]
The a-Series has a 144-bit memory bus, with 128 bits used for data and 16 bits for ECC. There are three memory banks, each consisting of two DIMM slots, for a total of six DIMM slots, which supports 32 MB to 1.5 GB of memory. These machines accept standard unbuffered only PC100 ECC SDRAM DIMMs with a maximum capacity of 256 MB per DIMM, which must be installed in identical pairs in order to match the width of the memory bus.[6]